Smith Wesson SW MP Shield SD9 SD SD40 MP SD40VE/zigana px9 Pistol Mounting Plate for Vortex venom, burris fastfire, meopta, eotech mrds, docter, insight Red Dot Reflex Sight

I mounted this base on a SD9VE along with an ADE RD3-006b green dot sight. They worked perfectly together. The base fits very well and holds my sight tightly. After a couple hundred rounds everything is still tight and the sight is holding zero. I'd buy this again.

Didn't know theses were out there because I wasn't looking, I had a rail a $70 rail I bought 3 yrs ago, when someone showed me this I looked at all of them and this one looked like the best, it's on my M&P 2.0 fits perfect looks fantastic and I ordered another for my other gun.

First off very easy to install it slid right into the rear sight slot of my SD9VE. Lined the holes up and tightened the screws down easy as that. My firefield sight mounted perfectly onto it. You will not find better value for the money.

The set screw on the factory sight was the most difficult task of the install. The rear sight on this pistol drifted off easily with a brass punch and since I knew about the spring from a previous build, I didn't have to search for that :)

I actually ordered this for my SAR K2P, as it uses the same mounting as S&W M&P dove. I ordered this specific one for two reasons, price and shipping quickly. For the price, i was expecting a ok product. But what I received was NICER than the kits I looked at in person at a local gun store. Blemish free and just all around good looking. Oh! The screws came with blue loctite on them. Its a small thing, but I was happy to see that as well.

The sight installed easy and clean. Some things to look for when installing are the longer screws that need to be ground down about 2 to 3 mm then lock tight. when installing make sure you tighten each screw as you go to make sure the sight is level to the slide. 100% silicone all parts as needed to reduce any kind of vibrations between the mount and the slide and the sight bottom plate for water proofing. Make sure after you sight it in that you lock tight the set screws if needed. Installed with the Ade Advanced Optics rd3-006x Green Dot Micro Mini Reflex Sight for Handgun.

If it isn't apparent from the photos, there are two parts provided with this, the 'F1' mounting plate and the 'F2' dovetail insert. Two different length pairs of mounting screws are provided also. The dovetail fit the rear sight slot of my M&P 22 perfectly. The mounting plate is contoured to match the cross-section profile of the top of the slide. This was also a close fit and the result is a pretty flush mounting to the slide with no exposed edges. I bought this to mount an ADE sight which hasn't arrived yet, but I'm happy with this mount and confident that it will be fine. I assume it will work with other full size M&P pistols also, but not with the Shield models.

Use to mount to my SD9VE for the Holosun 407k. Had to drimmel off the front 2 studs in order for it to work, but it works great now! I obviously didn't buy it for it's original intended use.

Very easy to install...all the parts fit exactly and was installed on my S&W M&P 2.0 mm handgun.... I ordered this part to work with my Vortex venom red dot sight and would recommend it and would use another one on another gun if I get a second Vortex... great product and great price..

I have purchased this one for my Smith and Wesson mp and two for my Spring Field Armory XDS and they all fit very well , you just have to make sure to use long enough screws,but for the price the plates and the green dots are excellent , Thanks guys

The plate works well, and works on my SW SD40VE (CA compliant) with the Loaded Chamber Indicator.

Very pleased with how easy to install sights in on zero and is perfect for ranging and hunting