The ACCU Wedg eliminates play between the upper and lower and prevents play from developing in those rifles that don't currently have any perceptible play.
This is perhaps the least expensive of all the 223 rifle many potential accessories, yet it adds immeasurably to the security and surety of the most basic element of any weapon. Installation is a breeze.
One needs only proceed through the first step of a normal field stripping in order to install the ACCU-Wedge.
It fits easily into the slot just below the assembly pin.
The ACCU-Wedge fits between the receiver and the trigger assembly housing and completely eliminates any play and "rattle". you always can cut the bottom a little for make it fit batter for your rifle.
Pack of 10!
51 Reviews Hide Reviews Show Reviews
-
JA,
I bought this for my DDM4V11. The weapon is already tight and snug. I bought this because I purchased a Ghost 300BLK upper and noticed a slight wiggle. Now my 300BLK setup is nice and tight. Well worth the buy and comes with spares for any future rifle purchases.
-
Davy
This wedge is a little tight, but it worked excellent to sure up the rattling between the upper and lower where they hinge together. If your AR receiver has a rattle, this wedge will definitely take out all the loose play. It also helps some with accuracy.
-
Diesel frk,
If there's play between your upper and lower these will help. It go in you lower in the fire control box under the rear take down pin. It makes assembly and disassembly a littler harder but that is remedied with pressure to the upper pressing it to the lower while you pop out the rear take down pin
-
Accu wedges!
Exactly what I was looking for!! Product arrived in a timely manner. Fit my ar perfect. Takes the slack out of the upper and the lower fitting together!!! Wish that I would have ordered black though!!!!!!!!!!!!!!! Great product, would definitely recommend this to anyone looking for good product for their gun.
-
It’s a good wedge
It works like it supposed to. Some people complain about them because it’s not a good fit. Every ar are built deferent and some time you have to shave off a little so it would be a perfect fit for your ar.
-
Accu wedge
Accu wedge remedies the loose or slop from lower to upper receiver. Seems to be a little tight when first installed, but will break in and retain memory. Deffinately recommended if your concerned with shake or play in your receiver fit.
-
Takes the wiggle and rattle out.
Works as intended. At received matches description. Some minor trimming may be needed to allow takedown pin to move freely as it applies pressure between upper and lower. Trimming can be done with a knife or sharp scissors
-
Nick
Bought these on the recommendation of a friend. Work pretty nice, tighten up the fit between the upper and lower. You will have to do a little trimming and use a couple of them as well. But it’s easy enough.
-
Great Product
Prior to adding the wedges, my rifle was really loos and my groups were not as tight as I wanted. After adding the wedge into the rifle, I have able to achieve 1/2 in groups. In my case I did not have to trim it either, it dropped in.!It’s been a great addition!
-
Tightens the rifle up nicely
I ordered a pack of these and received 5 wedges. They make some receivers almost too tight to close buy could easily be trimmed up. The first pack had 5 and I ordered another for some friends. The second order only came with 3 wedges. I contacted OP and they advised it should have 5. They made it right and shipped another pack also only containing 3 wedges. I would recommend these if your lower receiver doesn't have a set screw. Just beware, it will probably contain 3 wedges.
-
They do the job
As many have mentioned I did have to trim it down a hair but it has sured up that tiny bit of play between the upper and lower. That bit of movement was driving me nuts so I was glad to find these. I cannot speak on its longevity though.
-
Good to go
I have been using these Accu-Wedges for many years in all my AR-15's. They work. It is really a "no-brainer", they remove the wobble between the upper and lowers, they don't cost much, and they are simple to install.
